control units

DOOR CONTROL

Solutions according to your requirements

We deliver control units certified in accordance with ČSN EN 50 155 for a wide portfolio of means of transport. Communication may run either through RS232 interface or CAN. We will adjust the parameters as required by the customer.

Technical parameters of units:

  • Wide operating temperature range
  • Short-circuit and overload resistant outputs
  • Door control using feedback with adaptive control function
  • Inputs for connecting safety elements such as photoelectric sensors and safety edges
  • Communication via CAN, RS232
  • Can be connected to CAN bus supporting full door control via CAN
  • Diagnostics, parameterization and software reprogramming

RC2

RC2 control unit is used for renovation of door entries with standard drive, for controlling of folfing door, out-sliding door and in-slidding door for trams, trolley-buses and buses.

RC3

RC3 control unit is used for renovation of entrance sliding door for the metro.

RC4-V1

RC4-V1 control units is used to control sliding plug door. It allows connection to the control panel trough CAN data busbar and sending of statistics and events.

RC4-FD

RC4-FD control unit is used for sliding plug drives. This unit also allows connection to the control panel through CAN data busbar and sending of statistics and events. The control units are equipped with “adaptability” function, i.e. the door system may be adjusted to changing conditions during operation.

EB40

EB40 control unit is used for sliding olug drives and sliding drives with higher demands for numbers of inputs nad outputs. Similarly to the previous units, it allows connection to the control panel through CAN data busbar and sending of statistics and events. This control unit is also equipped with “adaptability” function.

EB43

EB43 control unit is used for entrance sliding door of tube type, for interior passage door and for sliding door in cargo area. It allows connection to the control panel through CAN data busbar and sending of statistics and events. The function of advanced diagnostics allows saving statuses and changes of inputs and outputs for each event.